|
Manual Fire Alarms
Stand-Alone
Fire Alarm
Manual
fire alarms suitable for small premises. All alarms incorporate a manual
call point and 105dB @ 1m sounder.
Gemini
GX20
* Suitable for small buildings with no requirement to meet BS5839
* Up to six GX20's may be connected together with simple twin core wiring
* Cannot be linked to smoke detectors
* Battery operated, using two PP3 size alkaline batteries
* Battery and cable monitors give warnings of low battery and disconnection
between units
Gemini
GX100
* Complies with BS5839 Part 1 Appendix G
* Ideal for small premises up to 2000 square metres where there are
no requirements for zoning or automatic detection to awaken sleeping
persons
* Mains powered with integral rechargeable battery back-up (12 volt
0.8Ahr sealed lead acid battery)
* Five GX50 extension units can be connected to a GX100, using a simple
two wire connection and still maintain full sounder output in excess
of thirty minutes in the event of mains failure
- Gemini
GX20 (Battery) fire alarm
- Gemini
GX100 (Mains) fire alarm
- Gemini
GX50 extension
Alarmed
Emergency Key Boxes
This
alarmed emergency keybox is a purpose designed plastic box to which
a clear plastic window can be fitted in order to retain a key or access
control card. A recess enables the window to be removed in an emergency
to retrieve the key. An integral electronic alarm sounds immediately
any attempt is made to remove the window. The window is designed in
such a way that it cannot be refitted after removal. The alarm can be
tested periodically without removing the window. All key boxes are supplied
with fixing screws and plugs etc. Available in red as standard.
- Keybox
with integral audible alarm (with PP3 battery)
- Keybox
with alarm switch
- Windows
for keyguard (pack of 4)
Exit
Door Alarm (Exitguard)
The
Exitguard is ideal for Supermarkets, Hotels, Restaurants, Warehouses,
Leisure Centres and all types of public buildings. An integral alarm
is sounded immediately as the door is opened. The alarm can be delayed
by an integral preset timer which is adjustable at the time of installation.
A four position keyswitch allows the unit to be Isolated (O), Tested
(I), or Switched On to either Manual Reset (II) or Auto-Reset (III).
The automatic reset delay is controlled by a second timer. Both timers
are independently adjustable to a maximum of 2.5 minutes. The Exitguard
can therefore be used with the minimum amount of supervision. If the
manual reset mode is selected then a key is required to silence and
reset. Supplied complete with 9V PP3 size alkaline battery.
- Exitguard
- 156 width x 90 height x 57 depth (mm)
Extinguisher
Anti-Theft Alarm
The
'Extinguisher Anti-Theft Alarm' is an effective way to stop vandalism,
misuse or theft of fire extinguishers. This sturdy, tamper proof, self
contained device incorporates a unique and patented steel cable operated
switch mechanism, which activates a piercing 100dB alarm when the extinguisher
is removed from its normal position.
* Sturdy
red fire resistant polycarbonate housing
* 100dB integral sounder
* Easy to install and maintain
* Complete with operating cable, aluminium seal, tamper key screwdriver,
deactivation cable for servicing extinguisher and 9V DC battery
- Extinguisher
anti-theft alarm
General
Purpose Alarm
Multipurpose,
economic alarm based on a simple reed switch and magnet device. The
100dB sounder will immediately activate when for example a cabinet is
opened or equipment removed. The alarm will continue to sound for three
minutes after the door is closed or equipment is replaced. If the equipment
is not replaced / door closed, the alarm will sound for the life of
the battery.
* Hidden
activation switch
* Easy to install and maintain
* Complete with operating cable with reed switch, and 9V DC power source
Alarmed
Call Point Cover
A
hinged clear polycarbonate cover, that can be simply fitted over a manual
call point, to help prevent tampering. The cover is fitted with a piercing
alarm which sounds when the cover is lifted.
* Helps
deter accidental or malicious false alarms without restricting legitimate
alarms
* Suitable for fitting over many call points
* Can be used with KAC call points
* Use without spacer for flush mounted call point
- Alarmed
Call Point Cover
- Mounting
base
|
